Fire 8 Mode Sleeper MOD KIT with BURST!! Works on
all XBOX 360 Controllers!
ships within one business day!!
RECEIVE KIT TO MOD XBOX 360 WIRELESS
CONTROLLERS. WORKS WITH BOTH THE NEW CG AND OLDER MATRIX
CHIPSET - GUARANTEED!
HIGH SPEED RAPID FIRE RATES FOR ALL
FIRST PERSON SHOOTER GAMES
Why buy our rapid
fire controller MOD kit?
There are many rapid
fire controllers out there from 3 mode to 18 mode and maybe even others. The reason to buy is not the number of modes. The reason to buy is for the fastest most
compatible chip available so you can have the FASTEST edge.
THE FASTEST SHOOTER ON EVERY ON-LINE GAME SESSION!!!
With the purchase of this item you
can MOD the XBOX controller that will change the fire rate of the
controller. The process is outlined below:
List of modes: (All patches
supported to date!)
1. Call of Duty
Modern Warfare 2/ HALO 1, 2, 3
2. Dual Call of Duty Modern Warfare 2 (for akimbo weapons)
3. Call of Duty 4, Army of Two
4. ALL Call of Duty’s, Rainbow 6, Left for Dead 1+2, best mode for halo
3 Battle Rifle is actually faster then a seven mode Battle rifle.
5. Call of Duty 5
6. Gears of War 1 + 2, Army of Two
7. Dual HALO 1, 2, 3
8. Double Shot Burst, Works with any game, great for 50 Cal Sniper and
the Fal single shot gun
Game compatibility: (All
versions/all patch updates some examples are listed below, this is only a
of Duty 4,5,6
- Battle Field! & Red Dead Redemption!
other first and third person shooter games and others…
CONTACT US FOR
QUANTITY ORDERS AT A DISCOUNTED PRICE!!!
The following is suggested
detailed installation guide click here.
Click here for : CG Chipset Schematics or Matrix Schematics
Install Requirements: Needle Nose Pliers, Wire Cutter, Exacto Knife, Hot Glue Gun and Torx Screwdriver for XBOX Controller.
Step 1: Remove serial number tag under battery compartment
with exacto knife. Remove
7 torx screws holding rear controller
cover on. Remove cover from controller. Holding sides of PCB gently wiggle controller
main board from housing.
Step 2: Bend
pins on chip 90 degrees so they are flat on the same plain as chip. Put some hot glue on mainboard
right side below trigger as shown in photo below. Glue
chip to mainboard. Wire
chip according to schematics belonging to your install package.
Step 3: Complete wiring installation as shown on schematics. Double check solder
joints. Glue wires in place using the four
corners method. Apply glue to exposed part
of chip to secure wires and parts to chip in case of vibration or shock
to controller. Place mainboard
back in controller and reassemble. Check LEDs for functionality. ENJOY!!!
Four corners method – When running wire on an Xbox controller
you should route wires around mainboard
from corner to corner. Run your wire from
outside of mainboard across any necessary
areas making sure not to cover the round contact points for the buttons
of the controller. Tack ends and corners
with a spot of hot glue to hold all wires in place.
BE THE FASTEST PLAYER ONLINE NOW......
*** WE HAVE THEM IN STOCK FAST US SHIPPING!!! ***
IF YOU HAVE ANY QUESTIONS FEEL FREE TO CONTACT
US AT ANY TIME BY PRESSING CONTACT SELLER LINK
I will only ship to a confirmed
authorized paypal address within the continental United
Customer Service M-F 10am-3pm EST EMail : firstname.lastname@example.org